Page 1 of 1

alternate configuration for Volcanicus (Dinobot combination)

Posted: Mon Jun 04, 2018 9:18 am
by Dominic
While looking for information on "Power of the Primes" Dinobots, I found a picture of an alternate configuration for Volcanicus.

The idea is to build a combiner using Grimlock and two limbs. Start with the standard torso mode, and attach the legs as normal. Then, unfold the standard robot arms. Attach the merge hands either over the hands or on the wrists. The result looks better than you might expect. (The biggest problem is the gaps on the chest, which are visible on the standard combination mode.)

It is also possible to use the tyrannosaur head for this merge form.


Now, which two limbs would you use for this?

Re: alternate configuation for Volcanicus (Dinobot combinati

Posted: Mon Jun 04, 2018 1:50 pm
by Shockwave
Slag and Snarl. Also, the combined mode feet can be used to fill in the torso and between all 5, you wind up with enough to have both feet and torso fill.

Re: alternate configuation for Volcanicus (Dinobot combinati

Posted: Tue Jun 05, 2018 8:21 am
by Dominic
The feet fill out the torso on the side. The gaps that bother me are the gaps on the combiner chest (or Grimlock's shoulders). Those cannot be filled.

Re: alternate configuration for Volcanicus (Dinobot combinat

Posted: Wed Jun 06, 2018 10:18 am
by JediTricks
Yeah, it's a gappy torso, they were too cheap on Grimlock.

Slag and Snarl are the right call, btw. They offer the best limb diversity and strength.

Re: alternate configuration for Volcanicus (Dinobot combinat

Posted: Thu Jun 07, 2018 8:28 am
by Dominic
Slag is in most of the two-limb configurations that I have come up with.

Slag/Snarl: evokes Generation 2.

Slag/Sludge: wave 1 Dinobots.

Slag/Swoop: Animated, which itself used the two characters that had the most chance to stand out.

Snarl/Swoop: wave 2 Dinobots.